#ULTRASONIC IPHONE CLEANER FULL#

It has temp and time control so I set it for 100* and about an hour, and they're ready for inspection and storage.Īs for turning something black, yes, it definitely will. I have an extra Excalibur 5 shelf Food Dehydrator that I use. I usually only run them through 2 times in the sonic cleaner since I'm not interested in bright and shiny. We both came running back to the Hornady One Shot Cleaning Solution. As to the other 'cleaning solutions' cooked up on the internet, I and my BIL tried them and were completely unsatisfied. In fact, since I just recently acquired 3000 pieces of nickel Federal 38 Special, they'll be getting a run through the sonic cleaner as well. In blissful ignorance, I have cleaned well over 3000 pieces of nickel case and have no problem stating that it works just fine on nickel. Only a comment that it's designed for brass and to not use on other materials.

The brass comes out of the Hornady solution very shiny and only requires a clear water rinse.Ĭlick to expand.I just double checked the label on my Hornady Cleaning Solution and I see no warning about nickel. It also has to be put through a baking soda wash/rinse to neutralize the vinegar. I did try a homemade mixture, vinegar, water, and dish soap, but the brass comes out dull, so it needs to be put through a tumbler cycle to shine it back up. Next time I have some dirty brass to clean I will post some before & after pictures.įor what I have invested it is a great addition to my reloading process. So to make a long story short total cleaning, rinsing, and drying time was about 46 minutes! Sure beats 1 to 3 hours in my media tumbler, which does not clean either the inside or primer pockets! The only downside I can see so far is Hornady warns not to clean nickel plated cases in their solution as it will turn them black. I rinsed them off and put them on a cookie sheet and put them in the oven at 200 degrees for about 20 minutes.

#ULTRASONIC IPHONE CLEANER FULL#

This unit does not come with a full basket, but is the same as the Lyman, so I ordered a basket from Lyman to use in it.įirst I ran some 40 S&W brass through it that was very dirty, 3 - 480 second cycles and it came out like brand new inside, outside, and even the primer pockets. I picked one up and bought some Hornady cleaner to use in it. I was looking at Harbor Freight and found this one: Ultrasonic Cleaner - 2.5 Liter I have been thinking about getting one for a a year or two, but the price was too much. If anyone has been thinking about investing in an ultrasonic cleaner for deep cleaning your brass here is my first reactions.

Ultrasonic iphone cleaner